Chihiros New Doctor – Electronic aquarium treatment
The Chihiros New Doctor is an electronic water treatment system for aquariums over 125 litres. Its three programmes for plants, fish and shrimp help limit algae and keep the water clear.
The Chihiros New Doctor is an electronic system designed to support the maintenance of freshwater aquariums over 125 litres.
Thanks to its micro-electrolysis process, the device periodically produces a fine mist in the aquarium. Its automatic programme adapts the device's operation to the tank volume and the selected mode.
Three programmes suited to your aquarium
The Chihiros New Doctor offers three operating modes:
• Plant mode: helps limit the development of green algae and maintain good conditions for aquatic plants.
• Fish mode: contributes to water maintenance and the reduction of undesirable micro-organisms.
• Shrimp mode: a programme suited to aquariums housing freshwater shrimp.
Main benefits:
• Helps limit the development of green algae
• Helps preserve clear, good-quality water
• Three programmes: plants, fish and shrimp
• Automatic operation according to the selected volume
• Simple touch control
• Discreet installation inside the aquarium
• Suitable for aquariums over 125 litres
• Suited to aquariums of around 45 to 250 cm in length
Conditions of use:
The Chihiros New Doctor must be used in water with a TDS below 500 ppm. It is recommended to measure this value before installing the device.
The mesh reactor is a wear part. To maintain optimal operation, the manufacturer recommends replacing it roughly every six months.
Installation advice:
Install the reactor inside the aquarium, in a well-circulated area. The reactor must remain fully submerged during operation.
Then select the aquarium volume and the programme corresponding to its inhabitants. Always follow the manufacturer's instructions during installation and commissioning.
Important information:
The Chihiros New Doctor is an aid to aquarium maintenance. It does not replace correctly sized filtration, water changes, parameter monitoring or regular tank maintenance.
Do not use the device in water with a TDS above 500 ppm. Unplug the installation before any handling in the aquarium.
